FAQs about tungsten carbide wire drawing dies
 
1, When will use t.c wire drawing dies?
When cost reduction is the top priority rather than the tolerance or the wire surface finish then tungsten carbide die is the best choice. We manufacture wide range of tungsten carbide dies. These dies are economical even in large size wire drawing applications. These dies are used mostly in drawing steel wires or where die tolerance and wire surface finish is not as important.
 
2，what’s the advantage of t.c wire drawing dies?
These dies are available at a very reasonable cost which helps in reducing the overall cost of production.
It is available in very large sizes thus It can be used for large size wire drawing applications.
It is more resistant to corrosion.
 
3, what the minimum and maximum size tc wire drawing dies can produce?
  Wire size from 0.1mm to 30mm.
 
4, what’s the nibs size you have
We have mold for 3x3mm, 9x6mm,13x10mm, 17x15mm, 20x17mm,22x18mm, 25x20mm, 30x24mm……up to 100x50mm.
 
5, How can I increase the uptime of my wire drawing machine?
Use good quality inlet wire/rod, and properly maintain your machine and lubricant. Choose the best drawing die material, use the correct drawing die size, and use proper inner geometries (angle and bearing) that match the wire alloy you draw.
 
6, How do I choose the right material for my drawing die?
Basically, the best material depends on the wire material you draw along with the amounts you draw. Please check the comparison page first to see which drawing die materials are available for the size you need to draw. And you can just call us, we will give you professional suggestion.
 
7, How to increase wire drawing speed?
From the drawing die side, use the correct drawing die size sequence matched to your wire drawing machine and wire alloy. 
 
8, How do I inspect my drawing dies?
Visually inspects the wire die's inner profile surface for sizes below 8 mm then a microscope would be your best option. For die sizes larger than 8 mm you can use a magnifying glass. For a rough-check of the diameter we suggest using check-pins. If you need a more accurate measure, pull wire through the die and measure the wire diameter with a micrometer or laser-mike.
 
9, How should I clean my drawing dies?
Depending on how dirty your dies are you may want to use a degreasing agent, an ultrasonic bath, compressed air and special cleaning paper.
 
10, Have cup-cone breaks when I draw my wire. What can I do?
Use good consistent quality inlet wire. Use a drawing die sequence that matches your machine, speed, and wire alloy. Make sure all drawing die geometries match the wire alloy you draw.
 
11, What is your minimum order or buy?
Usually it depends on the size, we can offer low MOQ for you.
 
12, Can you OEM according to our special design?
Definitely yes.
 
13, what’s your common delivery of wire drawing nibs?
For order not very big, we can finish it in 4 weeks. For bigger qty, need to check before placing order.
 
14, what’s your gurantee for your dies?
We have gurantee for all of our dies for 1 year.